Problem with USB interface selection under the LM Flash Programmer available interfaces on windows 10

POONAM GAJRIA

Hello,

I have installed LM Flash programmer-1613 on my windows 10 PC and I need to know the complete list of software and their versions that need to be installed to

get USB DFU option in the "Interface" menu list.

At present I only have LM Flash programmer installed.

Regards

Poonam

over 7 years ago

0 Ralph Jacobi over 7 years ago

TI__Guru*** 135355 points

Hello Poonam,

You will need to ensure the latest TivaWare USB drivers are installed for your device. This usually has to be done manually by directing Windows Device Manager to correct file folder. software-dl.ti.com/.../SW-TM4C-2.1.4.178.PATCH-1.0.zip

Furthermore, you may need to run the LM Flash Programmer in Compatibility Mode for Windows 7 as mentioned in the very last post of the related thread you linked.

Lastly, you should make sure your TM4C device has it's flash erased so it can be seen as a DFU device properly by the LM Flash Programmer.

0 POONAM GAJRIA over 7 years ago in reply to Ralph Jacobi

Prodigy 30 points

Thank you for the solution. It worked successfully.

Arm-based microcontrollers

Arm-based microcontrollers forum

Problem with USB interface selection under the LM Flash Programmer available interfaces on windows 10