is it possible to use the XDS110 debug probe with Energia

can altineller

Other Parts Discussed in Thread: ENERGIA, TM4C123GH6PM

Hello,

I am developing a project where I need to use both CCS and Energia on the same custom board with the XDS110 probe. (The custom board works and I normally program it with a Tiva-C board.)

Would that be possible and if so how?

Best regards,

over 7 years ago

0 Yordan Kovachev over 7 years ago

TI__Guru**** 161600 points

Which SoC is this?

0 can altineller over 7 years ago in reply to Yordan Kovachev

Expert 1760 points

What is the definition of SoC? Do you mean the microcontroller? It is a TM4C123GH6PM.

0 Ralph Jacobi over 7 years ago in reply to can altineller

TI__Guru*** 135355 points

Hello Can,

Per our TM4C forum guidelines, we do not support Energia for TM4C. Direct Energia questions to the primary Energia forums at: forum.43oh.com/.../ They should be able to address your question.

0 Ralph Jacobi over 7 years ago in reply to can altineller

TI__Guru*** 135355 points

Hello Can,

I see you rejected my prior reply but you didn't follow up with any reasoning to why, can you please clarify?

Also if you haven't seen them yet, our forum guidelines are posted here: e2e.ti.com/.../695568

0 can altineller over 7 years ago in reply to Ralph Jacobi

Expert 1760 points

Hello Ralph,

I am sorry for the delayed response. I understand this is not an energia forum, but I am not an energia user neither. I just needed to upload energia code to a custom board, with using the debug probe, for testing purposes, so I could import the project to CCS.

Here is what I did to solve my problem:

I used CCS in energia mode, which then allowed me to create a new target configuration with the debug proble, (which energia does not).

Best Regards,
Can Altineller

Arm-based microcontrollers

Arm-based microcontrollers forum

is it possible to use the XDS110 debug probe with Energia