Other Parts Discussed in Thread: TMDSFSIADAPEVM
Hello Every One!
I have some problems when use CLB to passthrough FSI signal.
Device: F280039C Launchxl Pad + TMDSFSIADAPEVM.
Config GPIO_54 as FSI_RXCLK, GPIO_52 as FSI_RX0. at the same time, Config CLB INPUTXBAR: the Source of XBAR_INPUT1 is GPIO54, the source of XBAR_INPUT2 is GPIO52.
Config CLB OUTPUTXBAR, Pin78 as CLB1 OUT0, Pin79 as CLB1 OUT1
The problems is that the CLB output is not same as FSI RX_CLK,we need some help to sovle this, or if this usage is allowed.
The figure yellow line is FSI RX_CLK, Green line is Passthrough signal use CLB internal