BLDC motor with hall sensor

Samuel Christopher

Other Parts Discussed in Thread: TMDSCNCD28035, CONTROLSUITE, MOTORKITSCNCD69MISO, MOTORWARE

suggest me the best solution for , BLDC motor(3-phase,1.1 hp,310v dc,4600rpm,4 poles,5amps) ) with hall sensor in C2000 piccolo or delifino boards along with hardware equipment

over 12 years ago

0 Gautam Iyer over 12 years ago

Guru 192875 points

Hi,

Why don't you go through this:

http://www.ti.com/lsds/ti/apps/motor/brushless_dc/overview.page

Regards,

Gautam

0 Igor Gorbachev over 12 years ago

Guru 20525 points

Hello!

Also please pay attention on these threads

http://e2e.ti.com/support/microcontrollers/c2000/f/171/t/286994.aspx

http://e2e.ti.com/support/applications/motor_drivers/f/38/p/258667/915458.aspx#915458

Regards,

Igor

0 ChrisClearman over 12 years ago in reply to Igor Gorbachev

TI__Guru** 119680 points

If you are set on doing hall sensored BLDC you should use TMDSHVMTRPFCKIT, there is a SW example that runs on Piccolo tmdscncd28035. Software support from www.ti.com/tool/controlsuite

I also recommend purchasing TMDSCNCD28069MISO controlCARD which will allow you to plug in to the same Hv inverter and try sensorless InstaSPIN-FOC and sensored or sensorless InstaSPIN-MOTION. These are supported through www.ti.com/tool/motorkitscncd69miso and www.ti.com/tool/motorware

0 Luis Villafuerte over 11 years ago in reply to ChrisClearman

Prodigy 20 points

Hi I am a student from Ecuador, I have purchased the TMDSHVMTRPFCKIT, I think it is incredible; recently I have been studying the two control methods for BLDC motor, but I have trouble understanding the HALL3_DRV module used in the Sensored Trapezoidal Control, I wonder if you could explain certain details of the module (operation principle) especially the HALL3_DEBOUNCED_MACRO I have read the software flowcharts on the guide but there is no the technical background.

I have read about the InstaSPIN-FOC technique and I think it is far superior to the other techniques, unfortunately today in my coutry is difficult to import, but as soon as I have the resources I will import it.

0 ChrisClearman over 11 years ago in reply to Luis Villafuerte

TI__Guru** 119680 points

documented

C:\ti\controlSUITE\libs\app_libs\motor_control\drivers\f2803x_v2.1\~Docs\DMC2803x_DRV.pdf

you can go read about using hall sensors in general, this may give you a better background than our docs provide on the principle of operation.

Luis Villafuerte said:
I have read about the InstaSPIN-FOC technique and I think it is far superior to the other techniques, unfortunately today in my coutry is difficult to import, but as soon as I have the resources I will import it.

Yes, it is! All you need is to purchase

TMDSCNCD28069MISO

and it will work with your TMDSHVMTRPFCKIT if it is Rev 1.1 (yellow PCB

C2000™︎ microcontrollers

C2000 microcontrollers forum

BLDC motor with hall sensor