• State
  • Locked Locked
  • Replies 1 reply
  • Subscribers 82 subscribers
  • Views 225 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

Starterware/TMS320F28069: Timing for Standalone Boot lines

ruediger.gerfried
Intellectual 880 points
Part Number: TMS320F28069

Tool/software: Starterware

Hello Hotline,

I want to use the Standalone-BootMode via SCIA ->GPIO34=H; GPIO37=L. I know I have to set the GPIO37 to LOW but please could you tell me when can I change the GPOI037 to HIGH again.

Regards

Gerfried

  • 0
    TI__Guru** 113875 points
    Pin value is used to decode the BOOTMODE. Once device jumps to SCI BOOT, the pin value can be changed. So basically you should be able to change the pin value in your application code.

    Vivek Singh