• State TI Thinks Resolved
  • Locked Locked
  • Replies 2 replies
  • Answers 1 answer
  • Subscribers 79 subscribers
  • Views 319 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

Original question:

MSP430FG4618: SMCLK stops on Code Composer Studio breakpoint

MSP430FG4618: Problem in Interfacing Msp430fg4618 with MSP-FET430UIF

Liu Yang
Genius 9090 points
Part Number: MSP430FG4618
Other Parts Discussed in Thread: MSP430G2553, UNIFLASH, MSP-FET

Hi Team,

I am Interfacing Msp430fg4618 with MSP-FET430UIF. as per this document
www.ti.com/.../slau278ah.pdf
i am using 2 wire method
but i am getting error Error connecting to the target:
Unknown device.
earlier it used to code MSP430G2553 , now i am coding MSP430fg4618 so do i need to cange the bootloader or some additional setting i have to do? what could be the problem , Can MSP-FET430UIF be faulty? beacuse i tried with many board but its still showing the same error? Can i download a bootloader again in MSP-FET430UIF? If possible then how to do that?
Thank YOU.

Beat Regards,
Tom Liu

  • 0
    TI__Guru 71216 points

    Hi Tom,

    If the MSP-FET430UIF can program the G2553 then it is not likely it is faulty.  What software are you using to program your target, CCS, Uniflash...?

    You don't need to change anything when switching devices.  Depending on the SW, the appropriate bootloader for this device is downloaded to the MSP-FET before the SW attempts to first program the device.  99% of the time this problem has to do with programming cable/wires too long or wrong cap on RST line.  Cable should be 20cm or less and you should have a 1nF (1000pF) cap on the target reset line.

    Is this a custom PCB with G4618?  Can you share schematic of MSP430?

  • 0 in reply to Dennis Lehman
    TI__Guru 71216 points

    Hi Tom,

    It's been a few days since I have heard from you so I’m assuming you were able to resolve your issue.
    If this isn’t the case, please click the "This did NOT resolve my issue" button and reply to this thread with more information.
    If this thread locks, please click the "Ask a related question" button and in the new thread describe the current status of your issue and any additional details you may have to assist us in helping to solve your issues.

**Attention** This is a public forum