A simple visual PIN and CLOCK configuration software ?

Tony Philipsson

Guru 12050 points

Grace is to complex for beginners (or even for me)

Is there a simpler program out there?

I started a html version and I need to add javascript to calculate the correct clks hertz and to save the config for C or Asm

0 Lukasz over 10 years ago

great idea,

for calculation and others complex instructions you can use php,

P.S.

you can hide restistor when io is not input

0 Tony Philipsson over 10 years ago in reply to Lukasz

Guru 12050 points

>P.S.you can hide restistor when io is not input

For anything that is an input, TA0.1 as capture could have the need for pull-up etc.

I think for P1.x Output, it will show the initial boot-up state you want e.g high/low instead.

0 Lukasz over 10 years ago in reply to Tony Philipsson

Tony Philipsson said:
I think for P1.x Output, it will show the initial boot-up state you want e.g high/low instead.

working with outputs you can show 1/0 or high/low

another method is show on/off, enabled/disabled, active/inactive

but in this case you must add checkbox inversion (inverted output or not)

**Attention** This is a public forum

MSP low-power microcontroller forum