MSP-EXP430G2: Educational BoosterPack MKII Compatibility Issue

Santosh Acharya

Part Number: MSP-EXP430G2

I disconnect Jumper J5 and connected BoosterPack to my LaunchPad und tried to run the examples for EducationalBP_MKII available in Energia but none of the examples are working.

over 7 years ago

0 Andre Frantzke over 7 years ago

TI__Expert 5490 points

Hi Santosh,

I have a couple of questions:
1. I assume you mean J5 on the BoosterPack. Why did you disconnect it?
2. If you just have the LaunchPad connected with PC, are you able to program it via Energia or CCS?

Best regards,
Andre

0 Santosh Acharya over 7 years ago in reply to Andre Frantzke

Prodigy 20 points

I mean J5 on lauchpad connecting P1_0 , Led1 und P1_6, led2. When i connect my launchpad i can program my launchpad but not educational boosterpack mkii

0 Andre Frantzke over 7 years ago in reply to Santosh Acharya

TI__Expert 5490 points

Hi,

can you please check if you selected the right Launchpad?

Please also note, that the MSP-EXP430G2553LP only has two single header rows, thus it may not support complete functionality. Please refer to this QuickStart guide. http://www.ti.com/lit/slau600

Best regards,

Andre

0 Andre Frantzke over 7 years ago in reply to Andre Frantzke

TI__Expert 5490 points

Hi,

do you have further questions? If not, please select "Resolved" in post above so this thread can be closed out.
Thanks a lot!

Best regards,
Andre

0 Andre Frantzke over 7 years ago in reply to Andre Frantzke

TI__Expert 5490 points

Hi,

I suppose that you were able to move on with your application as you didn't reply anymore, so I'll close this post.
Please feel free to comment again if you look for further assistance, it will re-open the thread.

Best regards,
Andre

**Attention** This is a public forum

MSP low-power microcontrollers

MSP low-power microcontroller forum

MSP-EXP430G2: Educational BoosterPack MKII Compatibility Issue