CCS/MSP430F5529: MSP 430 , drv 8350 , hALL SENSOR receive fault.

Scalery

Intellectual 540 points

Part Number: MSP430F5529

Tool/software: Code Composer Studio

I already has a thread on the E2E， but I am still waiting for the further answer.

over 5 years ago

0 Adam Sidelsky over 5 years ago

TI__Guru 65510 points

Scalery,

This post will be closed. I will checkup again on the prior post.

Regards,

-Adam

0 Scalery over 5 years ago in reply to Adam Sidelsky

Intellectual 540 points

hello Adam,

I have tried the new motor from TUNYO motor, It also indicated Hall Sensor Error. So likely it is not the motor problem but my board hardware problem.But Hall sensor signal is transmitted directly to the MCU MSP430F5529 end. what can cause this problem? was it MCU damage? hope to reveive your reply soon.

Best Regards

Scalery.

**Attention** This is a public forum

MSP low-power microcontrollers

MSP low-power microcontroller forum

CCS/MSP430F5529: MSP 430 , drv 8350 , hALL SENSOR receive fault.