DRV8316REVM: Unable to connect to web GUI

Cherry Zhou

Part Number: DRV8316REVM
Other Parts Discussed in Thread: LAUNCHXL-F280025C, LAUNCHXL-F280049C, TMS320F280025C

Hi team,

The LAUNCHXL-F280025C +DRV8316REVM kit cannot connect to the web GUI, here is a screenshot of the GUI interface:

Also the installation journal has a prompt to install error: https://e2echina.ti.com/cfs-file/__key/communityserver-discussions-components-files/121/ti_5F00_emupack_5F00_5.1.641.0_5F00_install.log

Could you help check this case? Thanks.

Best Regards,

Cherry

over 1 year ago

0 Davis Jackson over 1 year ago

TI__Intellectual 1790 points

Hi Cherry,

Thank you for posting this question! I will look into this issue and aim to provide an answer by the end of the week.

Best,

Davis

0 Davis Jackson over 1 year ago

TI__Intellectual 1790 points

Hi Cherry,

The InstaSPIN GUI is configured to work with the LAUNCHXL-F280049C per the readme note attached under the Help button. Since the customer is using the 280025C, this might explain why all of the parameters are marked with an X. For more information on how to configure the code or access the software for this launchpad, please refer to the software section of this user guide: https://www.ti.com/lit/ug/spruiw8/spruiw8.pdf?ts=1688152600328&ref_url=https%253A%252F%252Fwww.ti.com%252Ftool%252FLAUNCHXL-F280025C.

Best,

Davis

0 Cherry Zhou over 1 year ago in reply to Davis Jackson

TI__Mastermind 22235 points

Hi Davis,

Thank you for the support.

The issue still persists when configured to TMS320F280025C as the following figure shown:

Thanks and regards,

Cherry

0 Davis Jackson over 1 year ago in reply to Cherry Zhou

TI__Intellectual 1790 points

Hi Cherry,

I will need to discuss this issue more with my team for further feedback by the end of the week.

Best,

Davis

0 Davis Jackson over 1 year ago in reply to Cherry Zhou

TI__Intellectual 1790 points

Hi Cherry,

I believe the GUI is programmed to work specifically with ports for the 280049C. This will cause issues when trying to use the 280025C. The customer might be able to change the port definitions in the source code but the online GUI will only work with the 280049C.

Best,

Davis

Motor drivers

Motor drivers forum

DRV8316REVM: Unable to connect to web GUI