Hi Team,
Could you help share a register configuration item for driving a DC motor in continuous mode, or a reference routine? Thanks.
Best Regards,
Cherry
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Hi Team,
Could you help share a register configuration item for driving a DC motor in continuous mode, or a reference routine? Thanks.
Best Regards,
Cherry
Hey Cherry,
Per 8.3.1.1.1 Continuous Mode (Without PWM), The half-bridges are configured to operate in the continuous mode without using any PWM switching by default. Any high-side or low-side switch is switched on by individually setting the high-side enable bits (HBX_HS_EN) and low-side enable bits (HBX_LS_EN) in operation control registers (OP_CTRL_1, OP_CTRL_2 and OP_CTRL_3).
See 9.2 Typical Application for the general wiring setup.
Also see the DRV8912-Q1EVM GUI User's Guide and DRV8912-Q1EVM User's Guide
Regards,
Jacob