DRV2625: DRV2625 VDD current have negative

Hey Poki,

I see your waveforms and understand what is being shown in the top image but could you explain what is the waveform in the bottom image.

It is not normal for the DRV2625 VDD current to read negative values. Can you draw a diagram or show me the configuration of your measurement to make sure you are properly recording from the VDD pin. To properly measure current you would need to put the probe at the VDD pin and not at the output where the H-bridge has the current switching directions.

Best,

Carson Allen

LPAA Applications

Hi Carson,

1. The bottom image is the detail waveform (you can see time scale from 10ms to 2us)

2. YES we use current probe to measure VDD pin, not OUT+/OUT-, we remove R424 resistor, jump wire from R424.1 and R424.2 pad, and use current probe measure current through this wire

Poki

Hey Again Poki,

I see your set-up but can you explain what is SYS_PWR vs +2V85_SBB2 and why you have both of those connected to the VDD via resistors?

Best,

Carson

Hi Carson,

The SYS_PWR is reserve for another supply for DRV2625, we didn't mount R480 resistor so you don't need care about this

Also we found that if LRA vibrator no fix well at object, the OUT+/OUT- waveform is not normal

So will it cause current become negative?

Thank you~~

Poki

 e2e.ti.com/.../3416990

Hey Poki,

The issue with it the LRA not being fixed affecting the waveform should not be affecting the current  to go negative at the VDD pin.

I am going to perform a measurement of my own to determine what the current should look like, but can you tell the exact mode of operation and waveform you are playing so that I can set it up under the same conditions?

Best,

Carson

Hi Carson:

We are using I2C to control, NRST is high no matter LRA vibrate or not, and waveform is Strong click-100%

Thank you~~

Poki

Hey Poki

I went ahead and did my current measurement and yielded this plot,

As you can see the current never goes negative and rests at a value of about 2.5 mA. This is what your plot should more or less look like.

Can you take a measurement of the voltage & current waveforms of the output of the device that would correspond with the Vdd current waveform from above?

Also are you using open or closed loop?

Best,

Carson

Hey Poki

I went ahead and did my current measurement and yielded this plot,

As you can see the current never goes negative and rests at a value of about 2.5 mA. This is what your plot should more or less look like.

Can you take a measurement of the voltage & current waveforms of the output of the device that would correspond with the Vdd current waveform from above?

Also are you using open or closed loop?

Best,

Carson