Hello Guys,
Good day.
Our customer is planning to use only one output of the converter. He think its possible by putting the \EN2 to high level, and \EN1 to low level.
And by connecting the PVDD1, BOOT1, SW1, GND, FB1, BP, SEQ, ILIM2. Also, leaving not connected the PVDD2, BOOT2, SW2 and FB2.
Will this work ?
Also, the inductors used on the example on the datasheet is different from those used on the EVM. Was it because they are designed at different output current levels? Could you provide more details?
Thanks and regards,
Art