Is the feeding time and delay time affected by the working temperature? Do you have a specific value? For example, at - 40 ℃ and 125 ℃, how will these two time parameters change? How much has changed?
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Is the feeding time and delay time affected by the working temperature? Do you have a specific value? For example, at - 40 ℃ and 125 ℃, how will these two time parameters change? How much has changed?
Hi Zhang,
I was able to find some data but I am still trying to sort it all out. I am not sure if the data has all the temp data points. Let me continue to compile it and see what I have. I wanted to let you know what I am still trying to find the data for you.
Ben
Hi Zhang,
We have some limited data that shows +/- 20% from the min and max limits shown in the datasheet. Because the design is old, the data that I have found cannot be guaranteed over temperature. Please use what I have mentioned as a guideline for over temp behavior. Thanks!
Ben
Hi Zhang,
It has been a week since the last time I replied to your thread. Again, please let me know if you have any additional questions regarding TPS3824-Q1. If there are no further questions and you were satisfied with my answers, please close the thread by clicking on "resolved". Thank you.
Ben