Kindly review the power supply section which is attached below.
from 5V converts it to 1V
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Kindly review the power supply section which is attached below.
from 5V converts it to 1V
Hello user,
The schematic looks fine to me. The component selection: input/output capacitors, inductor value and Rset value are according to datasheet.
Just make sure when you connect the PG pin that you use a pullup resistor connected to any voltage rail less than 5.5V (max).
Let me now if you have any further questions or comments.
Thanks a lot!
Regards,
Dorian
Hello user,
Do you have any further questions here?
Let me know.
Thank you very much!
Regards,
Dorian
Hello user,
Due to inactivity, I will close this thread.
If you have any further questions or would like to re-open the thread, please reply below.
Thanks a lot!
Regards,
Dorian