Hi team,
Can I measure phase margin and draw a bode plot of LP8752x-Q1 by inserting series resistor in between OUT and FB_Bx pin?
regards,
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Hi team,
Can I measure phase margin and draw a bode plot of LP8752x-Q1 by inserting series resistor in between OUT and FB_Bx pin?
regards,
Hello Tsuji-san,
Yes it is possible. You can check this document for basic connection diagram for the measurements we have done:
https://www.ti.com/lit/an/snva881/snva881.pdf
Make sure the injected signal amplitude is not too high, we have typically used 10...20mV signal level.
Thanks.
Regards,
Tomi Koskela