Hi Expert,
May I know the risk or anything impact if the R2(bottom) of feedback resistor out of range 10k to 20k ? due to the datasheet show as below and, customer would to know the impact, if use 9.3k or others of R2 selection.
Regards,
Mark
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Hi Expert,
May I know the risk or anything impact if the R2(bottom) of feedback resistor out of range 10k to 20k ? due to the datasheet show as below and, customer would to know the impact, if use 9.3k or others of R2 selection.
Regards,
Mark
Too large or too small resistances in feedback can cause noise issues or have an impact on efficiency. Using a 9.3kOhm, when the recommendation is between 10kOhm to 20kOhm should not have any noticeable consequences.