Other Parts Discussed in Thread: CSD16406Q3
Dear team,
I have used BQ29728DESR IC in my sensor circuit. It is used to protect a 3.7V 500mAh LiPo battery. My charge current is less than 250 mA. I am using two CSD16406Q3 charge MOSFETs.. Unfortunately, I cannot change the MOSFETs in the circuit. However there is a series 0 ohm resistor is the circuit (R12). Please see the screenshot below.
These are my requirements. I need over current discharge protection and over current charge protection --> 1A. Is there a way to achieve this requirement using my current setup? Can I adjust the value of R12 to meet my requirements. I am a little bit confused with the calculations here. So can you please suggest the value of R12 for my circuit?
Your help is highly appreciated.
Thank you.