I am using LM5022 to boost voltage from 15V to 60V. But I am getting output as same as input. Kindy suggest.
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
I am using LM5022 to boost voltage from 15V to 60V. But I am getting output as same as input. Kindy suggest.
Hello Saravanakumar,
Thanks for reaching out to us via e2e.
The UVLO pin needs a voltage of 1.25V to start the device. Below that voltage it will hold the controller in reset.
With your chosen resistors (10k and 768R) you will need to supply a minimum of 17.53V to bring the part out of reset.
Best regards,
Harry