Dear TI Experts,
We encountered the following problems when developing TI UCD9081RHB (QFN32) as follows.
The blank IC can program the data file, and the comparison is no problem.
But in the block 0xE000 ~ 0xE1FF, after Erase (as shown below) according to the data programming process, the read value still does not change
Is this normal? Or are there any procedures we need to pay attention to?
User Data (0x1080 ~ 0x10FF) This block can be read, programmed and cleared normally.
Configuring(0xE000 ~ 0xE1FF) can be programmed and readable but cannot be erased.
Please help to solve the problem.
Thank you very much!