TUSB1064RNQEVM: original Project file (.pjt) and Binary file (.bin) about TPS65982

Shawn:

    Sent TUSB1064 project file, what customer  do you support?

Regards

Brian

Brian：

OK,Thanks a lot,my customer is  BYD and Volvo，i need to design a machine to test car charger, as you know,many cars has dp function via Typec.

Thank you again for your timely reply!

Best Regards

Brian:

Could you also  send me the original Project file (.pjt) and Binary file (.bin)  on the TUSB1046EVM evaluation board?

i need to design PCB Board about DP Source and DP Sink.So i need both of the two Project files(TUSB1046EVM and TUSB1064EVM).

It's really troublesome of you.

Bsst Regards

Shawn

Shawn:

   You need TUSB1146 or TUSB1046 project file? I just sent TUSB1146 file.

Regards

Brian

Brian：

Yes, I need Both of them.i check the file you sent, is it a drc format file？Actually，as some others have asked before, I also need the project files to customize some settings of the PD-Controller on the TUSB1046EVM and TUSB1064RNQ EVM. I need to use the “Application Customization Tool” to debug PD-Controller.

Regards

Shawn

Brain:

I also saw that someone in the forum raised the same question and the response from the forum manager.

And I already noticed that PS65982 is NRND (Not Recommended for New Design) , and I will  also use the TPS65987 in new designs.But for now I have the TUSB1046 EVM board and TUSB1064EVM board ,both of them are equipped with the TPS65982, and in order to continue my test I need at least to know what the current settings for the chip on this board are. Cause im studying how to set PD Controller.I am a bit anxious about this project, so thank you for your timely response

Regards

 Shawn

Shawn:

        I sent PD configuration tool to you as well.

        You can start with TUSB1146EVM and TUSB1064EVM, TUSB1046 is old device and performance is not good as TUSB1146.

Regards

Brian