This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

LM60430: About SW pin undershoot

Part Number: LM60430

Hello,

I measured the undershoot of the SW pin on the board I created for the LM60430.
Attach the measured waveform.
In addition, the measurement of the SW pin was carried out so that there was no influence from the ground lead of the probe.
The transient specification in the datasheet is -3.5V.
However, my measurement results show -5.3V.
There is an undershoot of about -5V in the SW waveform in Figure 8 of the data sheet, but are my measurement results correct?

Best regards,