Does TPS61230A have any constraints on the rise speed of Vin?
I want to use TPS61230A with Vin whose rise speed is 0.8V/1mS, will any issues arise?
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Does TPS61230A have any constraints on the rise speed of Vin?
I want to use TPS61230A with Vin whose rise speed is 0.8V/1mS, will any issues arise?
Hi Chikara,
Your slew rate of 0.8V/ms is very slow. I don't see any issue.
Best Regards,
Travis
Hi Travis,
Thank you for your prompt reply.
Has too late slew ever caused any issue?
Thanks & Best Regards,
Hi Chikara,
I don't see any issue unless you care about the total start up time, because the device will not start up until vin>2.5V.
Best Regards,
Travis
Hi Travis,
Thank you for your reply.
I don’t care the total start up time,I was concerned that TPS61230A work unusually due to the slow slew rate.
Thanks & Best Regards,