Hi experts
I'm working on a new design with this device, and want to minimize the current flowing through the ENable resistor divider network.
Can you provide information on the structure of the input pull-up described in datasheet section 8.2.2.1.1, and the maximum input leakage current in/out of the pin?
"The EN pin is internally pulled up to VIN and can be left floating for always-on operation. However, it is good
practice to use the enable divider and turn on the regulator when VIN is close to reaching its nominal value. This
will ensure smooth start-up and will prevent overloading the input supply."
Alternatively, what are the maximum values that can be used for RENT and RENB?
Thanks!
Jim B