TPS65988: When Configuring User use register, configuration always resets itself to 0x208

Dominic Woolston

Part Number: TPS65988

https://e2e.ti.com/support/power-management-group/power-management/f/power-management-forum/1296343/tps65988-unable-to-modify-customer-use-register-0x06-using-application-customization-tool

When configuring the user use register to any value. It always reads as 0x208. The above link provides more information on the issue

This occurs on the TPS65988DJEVM and occurs if the IO configuration option: Port 0 Load App Config 1 Event

Any help would be appreciated

8 months ago

0 Rohit Parashar 8 months ago

TI__Intellectual 2865 points

Hello Dominic,

I went through your earlier e2e thread.

I understand that if "Port 0 Load App Config 1 Event" is mapped to any GPIO pin then you find Customer Use register has 0x208 value.

Is my understanding correct?

I will check with Gautam and other team members who helped you in earlier thread and get back.

Best regards,
Rohit.

0 Dominic Woolston 8 months ago in reply to Rohit Parashar

Prodigy 20 points

Hi Rohit,

Your understanding is correct.
Did you get a chance to look at the issue yet?

Cheers,
Dominic

0 Rohit Parashar 8 months ago in reply to Dominic Woolston

TI__Intellectual 2865 points

Hello Dominic,

I see my team member is already working to help you on the thread you mentioned above. Please wait.

Best regards,

Rohit.

Power management

Power management forum

TPS65988: When Configuring User use register, configuration always resets itself to 0x208