Dear TI
Connect MODE pin to VDDA for interleaved signal-output operation,
when in signal-output operation,how to measure Bode Plot?
where to place the series resistor?
thanks!
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Hi Xing,
You need to put a resistor divider on the FB1 pin and insert the ripple injection resistor between the RFBT and Vout.
Regards,
Hongjia
Hi Xing,
Yes correct. The resistor divider is necessary for loop measurement.
Regards,
Hongjia