• State Resolved
  • Locked Locked
  • Replies 2 replies
  • Subscribers 62 subscribers
  • Views 65 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

BQ76905EVM: Buck enable function in BQ76905EVM

Vasu Poojary
Intellectual 380 points
Part Number: BQ76905EVM
Other Parts Discussed in Thread: BQ76905, TIDA-010268

Tool/software:

Hello Expert ,

I have gone through below block diagram of BQ76905 in TIDA-010268 document

In this BQ76905 IC generate Buck enable signal to switch on power supply to MCU.  I assume this will be used for low power consumption , but  not able to trace this in the detailed schematic .

Can you please help me how buck enable signal is generated from BQ76905 ?

thanks

regards

vasu

  • +1
    TI__Mastermind 32530 points

    Hello Vasu,

    I actually do not see where this is done on the schematic! Seems the BUCK_EN is coming off-board from the MSPM0 launchpad. The design guide just mentions that BUCK_EN needs to be set high to turn-on the buck converter.

    However, I believe the idea of the block diagram would be that REGOUT of the BQ76905 can be used as a BUCK_EN signal to the buck converter. The buck converter only requires a positive signal on its enable pin to power it up.

    Best Regards,

    Luis Hernandez Salomon

  • 0 in reply to Luis H. S.
    Intellectual 380 points

    Hello Luis Hernandez Salomon,

    Thanks for clarifications , i agree with you.

    Regards

    Vasu