• State TI Thinks Resolved
  • Locked Locked
  • Replies 1 reply
  • Answers 1 answer
  • Subscribers 63 subscribers
  • Views 65 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TPS929120-Q1: Current Reference Resistor selection

Anoop kumar N
Intellectual 898 points
Part Number: TPS929120-Q1

Tool/software:

Hello team,

I am verifying my customer schematic. The current requirement per each channel is 60mA. I think current reference resistor (R34) value is wrong. Kindly advice

Regards

Anoop

  • 0
    TI__Expert 7490 points

    Hi Anoop,

    Please refer to 7.3.2 Constant Current Output of the datasheet.

    you can follow below table to set the full current range via Rref and Kref and use CONF_IOUTx register to adjust the current that you need.

    BR,

    Hailee.