TPS2111A - D1

Newton

Other Parts Discussed in Thread: TPS2111A

For TPS2111A, if D1 is not driven by a logic gate and is pulled down and connected to a power supply, would that cause a problem? The datasheet doesn’t specify whether they’re Schmitt trigger inputs.

regards

over 12 years ago

0 Bob Kando over 12 years ago

TI__Genius 9415 points

The D lines may be connected to GND or IN1 either directly or through a resistor.

I don't think they are schmitt trigger input although they have a hysteresis between off and on thresholds.

They are still cmos and ttl compatible.

Power management

Power management forum

TPS2111A - D1