• State
  • Locked Locked
  • Replies 4 replies
  • Subscribers 64 subscribers
  • Views 692 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

LM5006 vs. LM5010A

David Dean
Expert 2305 points
Other Parts Discussed in Thread: LM5010A, LM5006

The LM5006 and LM5010A look like very similar parts, with very similar application circuits (especially when using a diode for the LM5006 instead of a FET). 

I am currently using the LM5006, and do not need the higher, 1A current limit of the LM5010A, but it would be a nice-to-have. 

I do, however, need the highest efficiency that I can find.  The datasheet efficiency numbers look close, but it is hard to tell for sure.  Given the same applications (say, 5V, 500mA output, 20Vin), is it possible to definitely say which regulator is more efficient?

Thanks,

Dave

  • 0
    TI__Guru 71445 points

    LM5006 can be more efficient because it can drive a sync fet to improve the efficiency. Refer to Figure 5 of the LM5006 datasheet.

    Thanks,

    Youhao Xi, Applications Engineering, TI SVA-PPD

  • 0 in reply to Youhao Xi
    Expert 2305 points

    I do know that the LM5006 synchronous FET option can improve efficiency, although I am using the diode option to take advantage of DCM at light loads.  Assuming that both parts are using the same diode, does one come in any more efficient that the other?

    Thanks,

    Dave

  • 0 in reply to David Dean
    TI__Guru 71445 points

    We do not have the test data for direct comparison, because the LM5006 was intended for sync fet app.   For your 20Vin, 0.5A 5Vout  application, it is believed that the two parts would be very close in efficiency if you do not use the sync fet feature.  LM5006 has slightly higher Rds(ON) and thus higher conduction losses. However, as the integrated FET is smaller, the LM5006 will have lower switching losses.  IMHO, the LM5006 is a better choice for your application.

    Thanks,

    Youhao Xi, Applications Engineering, TI SVA-PPD

  • 0 in reply to David Dean
    TI__Genius 15810 points

    Hello Dave,

    You could use Webench for your analysis. Without the entire BOM, it is a little difficult to estimate which part would be more efficient. Webench will let you customize your BOM so that both designs would have comparable BOMs and then you can compare the resulting efficiencies. I hope this is helpful.

    Regards,
    Akshay