Find a question about the part. Please give some comments about this issue? Or maybe some setting is be miss?
1.Set the GPI3 as reset trigger,just like the below.
2.Let the GPI3 output is high or low，but it could not trigger Reset.The below is the GPI3 waveform by monitor.
Comparsion UCD90124A with UCD9090 setting, find the red part setting in the UCD9090. But we could not find the red part in the UCD90124A. The UCD9090 can generate the reset signal by GPIO.
Here is a screen shot of the System Reset tab from the provided file.
Not sure why you would not be seeing the GPI options.
Can you provide the version of the Fusion GUI that you are using?
I did notice warnings about several configuratiuon parameters when loading the project file in the GUI which are not supported by the UCD90120A, did you port this configuration from another device in the family?
