LM53603-Q1: Load Current for Mode Change

Koji Hayashi

Intellectual 955 points

Part Number: LM53603-Q1
Other Parts Discussed in Thread: LM536035EVM

Hi all,

Please tell me the measurement method in Fig.4 in the data sheet.

Should I monitor the SW waveform?

This evaluation uses LM536035EVM. .

Best Regards
Koji Hayashi

over 7 years ago

0 JohnTucker over 7 years ago

TI__Guru**** 191445 points

Figure 4 is the low side switch valley current limit vs. input voltage. To measure it you need to monitor the inductor current during the off time (low side switch on time).

0 Koji Hayashi over 7 years ago in reply to JohnTucker

Intellectual 955 points

Hi John

Thank you for your quick response.

I’m so sorry.
wrong :Fig.4
correct: Fig.24

Please tell me how to measure Load Current for Mode Change.

Best Regards
Koji Hayashi

Power management

Power management forum

LM53603-Q1: Load Current for Mode Change