AUTOCRANKSIM-EVM: AUTOCRANKSIM-EVM

LeoChen

How many and what Automotive factory AUTOCRANKSIM-EVM could support? i can't find it clearly in "HVL068A Cranking Simulator User's Guide"

I find below Automotive factory Pulse support, if i buy a EVM, Do TI will support me GUI for this EVM?

.DaimlerChrysler Engine-Cranking Test Pulse, DC-10615
.Volkswagen Warm-Start Test Pulse, VW80000
.Volkswagen Cold-Start Test Pulse, VW80000

over 7 years ago

0 Karl Wallinger over 7 years ago

TI__Genius 16200 points

Hello Leo,

The User's Guide for this board shows the 3 pulses it supports in figures 3, 4, and 5. You can check this to see what are the profiles that it can generate.

There is no GUI for this board, the board is controlled by hardware which can be toggled by the user. Section 2.2.2 of the user's guide describes the function of each of these controls.

Regards,
Karl

0 LeoChen over 7 years ago in reply to Karl Wallinger

Intellectual 500 points

Dear Karl,
Thanks for feedback. Except 3 pulses(.DaimlerChrysler Engine-Cranking Test Pulse, DC-10615
.Volkswagen Warm-Start Test Pulse, VW80000
.Volkswagen Cold-Start Test Pulse, VW80000), i want to know whether Ti could support other software to support other automotive factory's pulses.

0 Karl Wallinger over 7 years ago in reply to LeoChen

TI__Genius 16200 points

Hello Leo,

The firmware is located on the PMP7233 product page under the Software section. The board uses an MSP430 to create these profiles, so you can download this firmware, update it for any profile that you want using code composer studio, and flash the updated firmware to create a different profile.

Regards,
Karl

Power management

Power management forum

AUTOCRANKSIM-EVM: AUTOCRANKSIM-EVM