This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

CSD87335Q3D: CSD87335Q3D - Stencil vs. Solder Mask

Part Number: CSD87335Q3D

Hello Team,

I have noticed that the CSD87335Q3D datasheet on the Stencil recommendation in section 11.3 recommends a single aperture for the pin 1-2.

On the other hand, in Figure 34, is shown that the pads for pin 1-2 are separated.

Can you recommend how the solder mask should be considering that the stencil has a single aperture and the pads are two?

It looks as a mismatch between the Figure and Stencil.