Other Parts Discussed in Thread: TINA-TI, , TPS62740
Tool/software: WEBENCH® Design Tools
Hey, I'd like to change the limit time for the startup simulation, but I can't see any way to do so... is it because my glasses are so bad, or, is it really not possible, or, is the capability hidden, or?
I'm running a simulation with a known-wrong inductor, and the 82740 should be going into pass-through mode, but it's switching, as the Vout is ramping up... problem is, the sim cuts off before Vout gets high enough to reach a point where the Vin is close enough to Vout to go into pass-through mode... It's also, from a design view, a bit strange that the device does not go into pass-through immediately; I'm guessing that it's looking at Vout, and Vout is still well below Vin, at start-up, but the device should 'know', based on Vsel, that Vin is too close to the selected Vout, and just go straight to pass-through, it seems.
Anyway, the main question is how I change the startup time to a greater value??
