TLV742P: Startup time variation

Takahiro Saito

Part Number: TLV742P

Hi team,

The datasheet shows a startup time value in a condition of Cout=1uF and Iout=150mA.
How much does the startup time varies when Cout and Iout are changed?
If you have simulation result or measurement data which describes startup time dependency on Cout and Iout, could you share it with me?

-I/O condition
Vin = 3.3V
Vout = 2.8V

Regards,
Saito

over 6 years ago

0 Ryan Eslinger over 6 years ago

TI__Guru 55940 points

Hi Saito,

The startup time for TLV742P is governed by the startup time of the internal reference voltage. As such unless there is enough output capacitance and/or load current during startup to trigger current limit, the startup time should not have much variation. If current limit is triggered during startup, then the startup time will be limited by the current limit.

Very Respectfully,
Ryan

0 Takahiro Saito over 6 years ago in reply to Ryan Eslinger

TI__Expert 5325 points

Hi Ryan,

Thank you for your reply. Your answer is helpful for me to understand the start up behavior.
I understand that the start up time does not change significantly when the load current is less than the current limit.

Regards,
Saito

Power management

Power management forum

TLV742P: Startup time variation