TPS51363: REFIN/REFIN2 indirect connection to GND

Nariaki Ogasawara

Part Number: TPS51363

Hi team,

Vout voltage is 1.05V at the customer's application, the setting of REFIN and REFIN2 is both GND. But The customer does not want to connect directly to GND. He tried to put a100Kohm between REFIN/REFIN2 to GND, in that case TPS51363 was not output.

What is recommended the resistance value?

Is it possible to describe more detail equivalent circuit of Reference Detection?

Regards,

Ogasawara

over 5 years ago

0 Yuchang Zhang over 5 years ago

TI__Mastermind 18510 points

Hi,

There are some internal sequence detection of REFIN / REFIN2, Connected to GND with 0ohm is recommendation value for the internal judgement.

Connect to GND can save two resistors and easy for layout, so I am wondering why customer does not want to connect directly to GND?

Yuchang

0 Nariaki Ogasawara over 5 years ago in reply to Yuchang Zhang

TI__Intellectual 1215 points

Hi Yuchang,

The reason is the customer side issue, he does not want to use 0 ohm.
Is it possible to use 1 ohm instead of 0 ohm?

Regards,
Ogasawara

0 Yuchang Zhang over 5 years ago in reply to Nariaki Ogasawara

TI__Mastermind 18510 points

Hi Ogasawara,
1ohm is acceptable.

Yuchang

0 Nariaki Ogasawara over 5 years ago in reply to Yuchang Zhang

TI__Intellectual 1215 points

Hi Yuchang,

Thank you for your response.
I have more questions.

1. What is accuracy of Vout? 1.05V +/- 1%?
2. What value is temperature drift for Vout?

Regards,
Ogasawara

0 Yuchang Zhang over 5 years ago in reply to Nariaki Ogasawara

TI__Mastermind 18510 points

Hi Ogasawara,

1.05V could cover +/-1% @TA -10~85C.

Yuchang

Power management

Power management forum

TPS51363: REFIN/REFIN2 indirect connection to GND