Hi team,
I have questions about TPS2543. Could you support?
Setup:
D+, D-: Pulled-up by MCU when device is connected. will be low when device will disconnected.
CTL(1-3): 111 = CDP Mode
1. I can see re-connection process as CDP Mode when disconnect -> connect CDP device on EVM. Does this mean TPS2543 can hand-shake automatically when device will be connected?
2. Does TPS2543 have a function of connect/disconnect detection?
3. Is there any other condition that TPS2543 will be hand-shake automatically?
Regards,
Kotaro Yamashita