UCC28019A: for AC24Vin

Hello ACGUY,

It is unusual to use the smart diode controller LM74670 and synchronous rectification on a pfc stage.
The very low input impedance into the large bus capacitance may cause a very large inrush current at start up  and failure of a component
unless some inrush protection is added to the pfc.
I think a startup resistor is required to pre charge the output capacitors.
Normally you would short out this resistor after a pre determined time and then enable the pfc.
The design should give excellent efficiency but it needs to be protected from transient conditions.

Im not sure what value of inductance is used but it needs to be 160uH or greater for this application.

Those are my only comments.

Hello John,

Thank you for your comment. About settings RC value, does this schematic have any mistake?

Best regards,

ACGUY