TPS3702-Q1: Threshold value

Hi,

is there anyone can support this question?

Thank u so much.

Hi Mark,

What do you have your SET pin connected to? Is it logic low or logic high?

Thanks,
Abhinav.

Hi Abhinav,

Thank you so much for your response.

I will guide our customer to communicate with you.

Regards,

Hi, Abhinav san.

Set Pin is connected to Vdd( =+3.3V ). 

Best regards,

Hiroshi.

Hiroshi-san,

Can I see the schematic of the block with this device? I suspect something is effecting the accuracy of the device.

Thanks,
Abhinav.

Hi, Abhinav san

thank you for reply.

see above schematic. TPS3702CX12QDDCRQ1 is installed at IC39A.

TPS3702CX33QDDCRQ1 is also installed at IC38A. but this one has no problem of accuracy.

regards, Hiroshi.

Hi Hiroshi-san,

I was under the impression that this was for the TPS3702, but the schematic shows TPS3808, can you clarify?

Thanks,
Abhinav.