HI,
The drain of CSD17307Q5A output is upward overshoot when the MOSFET from trun on to trun off，then it will fall slowly.I wonder to know what caused it，can anybody tell me？
In figure 1 the yellow waveform is the output of drain，figure 2 is zoomed out.
Many t
hanks.
Hi John,
Please look at the picture below. My design is as follows：
Is overshoot voltage caused by MOSFET parasitic capacitance（Cgs&Cds）？
Another question，When the MOSFET turns on and the drain current is very large, the falling edge is very slow, resulting in a much shorter emitting time of LD than the gate drive signal，do you have any good dSuggestions to improve it？（fiure 2）
The red is the voltage of drain，the green is the drive signal of gate.
