Other Parts Discussed in Thread: BQSTUDIO
I have triggered the learning cycle with the following parameters.
I have used the INR18650A battery as a 1s6p pack. I have 1.5A load and 4.0 V charger.
1. Start the learning cycle with the discharged battery (3.3 V). The update status is 0x04.
2. Wait for the fully charged (4.0V). Relax till VOK should clear and REST is set. QMAX is toggled and update status is 0x05 now.
3. Start the discharge cycle with 1.5A load. Wait for to discharge till 3.3 V. Relax for 5 hr. But update status is not updated to 0x06. What is the reason behind this?
I have attached config.gg file and log files. Please help me.
| Advanced Charge Algorithm | Low Temp Charging | Voltage | 4000 | mV |
| Advanced Charge Algorithm | Standard Temp Charging | Voltage | 4000 | mV |
| Advanced Charge Algorithm | High Temp Charging | Voltage | 4000 | mV |
| Advanced Charge Algorithm | Rec Temp Charging | Voltage | 4000 | mV |
| Advanced Charge Algorithm | Termination Config | Charge Term Taper Current | 300 | mA |
| Gas Gauging | Current Thresholds | Dsg Current Threshold | 60 | mA |
| Gas Gauging | Current Thresholds | Chg Current Threshold | 75 | mA |
| Gas Gauging | Current Thresholds | Quit Current | 40 | mA |
| Gas Gauging | Design | Design Capacity mAh | 15000 | mAh |
| Gas Gauging | Design | Design Capacity cWh | 5400 | cWh |
| Gas Gauging | Design | Design Voltage | 3600 | mV |
| Gas Gauging | FC | Set Voltage Threshold | 4000 | mV |
| Gas Gauging | FC | Clear Voltage Threshold | 3900 | mV |
| Gas Gauging | TC | Set Voltage Threshold | 4000 | mV |
| Gas Gauging | TC | Clear Voltage Threshold | 3900 | mV |
| Gas Gauging | State | Qmax Cell 1 | 2500 | mAh |
| Gas Gauging | State | Cell 1 Chg Voltage at EoC | 3990 | mV |
| Gas Gauging | State | Current at EoC | 300 | mA |
| Gas Gauging | IT Cfg | Term Voltage | 3300 | mV |
