Hi Team,
Good day, we received inquiry from customer that the TINA-TI does not provide output. The customer also tried the webench design provided from one of our Expert in the link below.
TPS5430: Spice model of this part is not working.
Customer issue please refer to attached "WEBENCH DESIGN issue".
WEBENCH DESIGN issue.zipThank you and looking forward for your kind response.
Regards,
Maynard
Hi Maynard,
Yes, you can use the Tina file which export form WEBENCE directly.
And if you directly use the file, you can get the output shown as below.
However, if you change the input to battery with 12V, there will be no output, which can also be seen from the transient analysis waveform shown as below.
Best regards,
Wendy
Hi Maynard,
It's something about the configuration of the model. If you use Vin 12V, click Analysis-transient- label the 'Use initial conditions' then click OK, then you can get the output.
Best regards,
Wendy
Hi Wendy,
Again thank you for your kind response.
Our customer already can output the said waveform.
The customer also want to know how to get the chart as below picture which get from tps5430 datasheet using TINA-TI ?
Regards,
Maynard
Hi Maynard,
It's the test result. However, if you use Analysis-transient- label the 'Use initial conditions' then click OK. Then click View-Show/hide curves and zoom the waveform, you can get the curves shown as below.
Best regards,
Wendy
