Hi Team,
There is a good new that DIN TPS7A8101-Q1
Please help check this SCH, THX
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Hi Team,
There is a good new that DIN TPS7A8101-Q1
Please help check this SCH, THX
Hello,
I will look into this and get back to you by the end of the day tomorrow.
Regards,
Srikanth
Hello,
I think the schematic looks fine. Please ensure that C29 and/or C30 are connected in the circuit. For stability, it is recommended that an output Cap of magnitude 4.7uF or greater is connected. Your EN pin and NR pin are correctly connected in the schematic shown, but please note that it is slightly different in comparison to the actual footprint of the device, where after the IN pins, we have the NR pin and then the EN pin.
Regards,
Srikanth