Texas Instruments (TI) Power management support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search power management IC content or ask technical support questions on everything from linear and DC/DC switching regulators to battery management and LED drivers. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Part Number: TPS53353 Other Parts Discussed in Thread: TPS53355
With PGOOD pulled up externally to an MCU or FPGA and an external voltage source, I would not expect any issues in the soft-start/mode selection so long as the probe monitoring PGOOD is…
Other Parts Discussed in Thread: LMG1210 Hi,
I want to use the LMG1210 for a new design, but I want to make sure that I can manufacture the part for a few years to come. My question is when was the LMG1210 released and when will it reach it's end-of…
Part Number: TPS54824
The device has been designed to prevent the low-side MOSFET from discharging a pre-biased output. During monotonic pre-biased startup, the low-side MOSFET is not allowed to sink current until the SS/TRK pin voltage is higher than…
Part Number: TPS54A24
Noise reduction for VIN and VOUT
There are things which can be done to reduce this noise such as adding a boot resistor or snubber, adding input or output caps for high frequency bypass or adding some inductive filtering.
Noise…
Part Number: LM5141 Hi there, about LM5141 test, I have some questions.
1. Equation(60) shows calculating Rcomp, how this equation comes from? any more detialed deduction?
2.when inductor is too large, loop instability occurs. You said it's because…
Part Number: BQ25890 Other Parts Discussed in Thread: BQ25898 , BQ25896 , BQ25895 , BQ25898D , BQ25898C , BQ25892 , , , BQ25895M
Hi,
When only the battery is present, ADC monitoring works only when the battery voltage is above the MINSYS register…
Other Parts Discussed in Thread: BQ25720 , BQ25730 , BQ25710 , BQ25703A , BQ25713 , BQ25731 , BQ25700A , BQ25708 , BQ25723 , BQ25713B How to terminate or set the termination current of the buck-boost chargers?
