Texas Instruments (TI) Power management support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search power management IC content or ask technical support questions on everything from linear and DC/DC switching regulators to battery management and LED drivers. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions

  • [FAQ] TPS7H5001-SP: How do I use the TPS7H500X-SP family as a voltage mode controller?

    Part Number: TPS7H5001-SP The TPS7H500X-SP family of devices are innately set-up for current mode control. Am I able to use the controller as a voltage mode controller?

  • [FAQ] BQ24610: What is the proper placement of bypass capacitors on VREF, VCC, and REGN for BQ24610 and other BQ246xx devices?

    Part Number: BQ24610 Please place all decoupling capacitors as close as possible to the IC pin they correspond to (following the Layout Guidelines and priorities for each device). However, please make sure that the VREF, VCC, and REGN pins are not loaded…

  • [FAQ] TPS23731: Vout setting on diode rectification and primary-side regulation (affect by VFCP)

    Part Number: TPS23731 I considering TPS23731 with diode rectification and primary-side regulation, referenced by answered below E2E thread. https://e2e.ti.com/support/power-management-group/power-management/f/power-management-forum/1169390/tps23731…

  • [FAQ] LP87745-Q1: Where can I find functional safety documents and full data sheet?

    Part Number: LP87745-Q1 The functional safety documents and full data sheet can be requested through following request link on product folder at https://www.ti.com/product/LP87745-Q1?keyMatch=LP8774-Q1 . Thanks!

  • [FAQ] LP87745-Q1: What is the naming convention of device part number?

    Part Number: LP87745-Q1 It is explained as following; LP8774 x x xx RXV R Q1 x : Number of regulators x : Switching Frequency (Fsw) and BOM/performance optimized options (1,2,or 3) LP8774x 1 : 17.6 MHz + full performance option or BOM/cost…

  • [FAQ] LP8758-B0: Can TI provide a solution size for the device?

    Part Number: LP8758-B0 Yes; the EVM design linked below can provide a reference of the solution size for these devices in every phase configurations: https://www.ti.com/tool/LP8758EVM?keyMatch=&tisearch=search-everything&usecase=hardware The picture…

  • [FAQ] LP8758-E0: Does TI have other existing OTP variants for quicker and easier samples?

    Part Number: LP8758-E0 Yes; listed in table picture below are existing OTP variants available for samples. Any new OTP variant needs to meet certain business size to start the process; please contact your local TI sales for more details.

  • [FAQ] LM26480: Is there a reference design of power up sequence implemented by RC delay on EN pin?

    Part Number: LM26480 Yes; a set of RC (Resistor and Capacitor) values were used on TI LM26480 EVM with VCC=3.3V on 3 "EN" pins (ENSW2, ENLDO1, ENLDO2) to control the power up delay for the sequence. ENSW1 connects to VCC directly without RC delay. …

  • [FAQ] BQ76952: Mask registers for Alarm Raw Status

    Part Number: BQ76952 Hi Team, I would like to ask a question: what is the mask registers? I am confused about the following words: Thanks a lot. BRs, Francis

  • [FAQ] TPS43330A-Q1: TPS43330 EMC Comparison between SS (Spread Spectrum) Disable/Enable

    Part Number: TPS43330A-Q1 TPS43330 EMC Comparison for SS.pdf

View FAQ threads