TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Power management

Power management

Power management forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Power management support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search power management IC content or ask technical support questions on everything from linear and DC/DC switching regulators to battery management and LED drivers. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] BQ24610, BQ24616, BQ24617, BQ24618, & BQ24630: Layout guidelines and example

    Michael Emanuel35
    Michael Emanuel35
    Part Number: BQ24610 Other Parts Discussed in Thread: BQ24617 , BQ24616 , , BQ24618 , BQ24630 Please see the below document for the layout guidelines and example for the BQ24610, BQ24616, BQ24617, BQ24618, and BQ24630. Layout Guidelines and Example…
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] TPS3840: PFET based disconnect on overvoltage

    Ajay Padgaonkar
    Ajay Padgaonkar
    Part Number: TPS3840 In case of an overvoltage situation, how can the downstream power tree be disconnected to protect it from such overvoltage? Can reset ICs not only sense the overvoltage but also drive a PFET switch to turn it off?
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] TPS62903: Reasons for Vout variations away from the expected value?

    Joseph Conrad
    Joseph Conrad
    Part Number: TPS62903 Other Parts Discussed in Thread: TPS62901 , TPS629210-Q1 What are some of the causes of output voltage variations in the TPS62901/2/3 buck converters?
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] TPS62130A: How to use the Power Good (PG) pin?

    Joseph Conrad
    Joseph Conrad
    Part Number: TPS62130A Other Parts Discussed in Thread: TPS62130 , What is the PG pin used for and what are the differences between the TPS62130 and TPS62130A?
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] BQ25171-Q1: Configuration Pins and Design Questions

    Bill Johns
    Bill Johns
    Part Number: BQ25171-Q1 The device can be configured to charge Li-Ion, NiMH and LiFePO using external pins. Can the configuration be changed during operation? Any other things I should note?
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] BQ25890: Why does ICHG reduce when reaching the maximum duty cycle for the BQ25890, BQ25890H, BQ25892, BQ25895, BQ25895M, BQ25896, BQ25898, BQ25898D, BQ24190, BQ24192, BQ24195, BQ24195L, BQ24196, BQ24295, BQ24296, BQ24296M, BQ24259?

    Wyatt Keller
    Wyatt Keller
    Part Number: BQ25890 The charger is basically a step-down DC-DC (buck) converter. It requires the input voltage to be higher than the output voltage with some headroom for normal operations. The maximum duty cycle specification is one of the factors…
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] BQ25890: Why does ICHG reduce during input voltage DPM (Dynamic Power Management) or the input current DPM for the chargers BQ25890, BQ25890H, BQ25892, BQ25895, BQ25895M, BQ25896, BQ25898, BQ25898D, BQ24190, BQ24192, BQ24195, BQ24195L, BQ24196,...

    Wyatt Keller
    Wyatt Keller
    Part Number: BQ25890 When the input source is over-loaded, it is either from the current exceeding the IINDPM (Input Current Limit) or from the voltage dropping below VINDPM (Input Voltage Limit). For the current to cause the input source to be…
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] BQ25618: [FAQ] Why does ICHG reduce when reaching the maximum duty cycle for the BQ25618, BQ25618E, BQ25619, BQ25611D, BQ25616, BQ25600, BQ25600D, BQ25601, BQ25601D, BQ25606?

    Wyatt Keller
    Wyatt Keller
    Part Number: BQ25618 The charger is basically a step-down DC-DC (buck) converter. It requires the input voltage to be higher than the output voltage with some headroom for normal operations. The maximum duty cycle specification is one of the factors…
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] BQ25618: Why does ICHG reduce during the input current DPM (Dynamic Power Management) or the input voltage DPM for the chargers BQ25618, BQ25618E, BQ25619, BQ25611D, BQ25616, BQ25600, BQ25600D, BQ25601, BQ25601D, BQ25606?

    Wyatt Keller
    Wyatt Keller
    Part Number: BQ25618 When the input source is over-loaded, it is either from the current reaching the IINDPM (Input Current Limit) or from the voltage dropping to the VINDPM (Input Voltage Limit). For the current to cause the input source to be…
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] TPS53353: [FAQ] VFB at Light Load Current vs Heavier Load Current

    Alec Biesterfeld
    Alec Biesterfeld
    Part Number: TPS53353 If using skip mode, a higher VOUT is expected at a light load when compared to a heavier load when the device is operating in CCM. This is not an artifact of the reference voltage (or feedback voltage) changing as a function of load…
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Not Answered

    LM5116: Input capacitor selection... 0 Locked

    327 views
    1 reply
    Latest over 8 years ago
    by Arief Hernadi
  • Suggested Answer

    bq34z100 VEN pin connection 0 Locked

    1641 views
    7 replies
    Latest over 8 years ago
    by TEC
  • Not Answered

    BQ20Z90: Asus battery UnsealKey/FullAccessKey 0 Locked

    5643 views
    11 replies
    Latest over 8 years ago
    by eric etienne
  • Answered

    WEBENCH® Tools/TPS62743: efficiency question 0 Locked

    1262 views
    4 replies
    Latest over 8 years ago
    by Alexander Alioshyn
  • Not Answered

    Universal Vehicle Battery Fuel Gauge 0 Locked

    1299 views
    3 replies
    Latest over 8 years ago
    by TEC
  • Answered

    LM5175: What limits LM5175EVM-HP Vin minimum at 6V? 0 Locked

    1494 views
    5 replies
    Latest over 8 years ago
    by Ann_Lien
  • Not Answered

    WEBENCH® Tools/LM5017: Problem to 5017 0 Locked

    2100 views
    8 replies
    Latest over 8 years ago
    by David Baba
  • Answered

    bq78350 Scaling Current and Capacity 0 Locked

    2133 views
    4 replies
    Latest over 8 years ago
    by Jorge Neiva
  • Not Answered

    BQ51021: soldering instructions 0 Locked

    1239 views
    1 reply
    Latest over 8 years ago
    by Bill Johns
  • Answered

    TPS2376-H: UVLO 0 Locked

    2259 views
    5 replies
    Latest over 8 years ago
    by Erin Zhang
  • Answered

    BQ76PL536A: Multi-Drop System GND problem? 0 Locked

    2005 views
    7 replies
    Latest over 8 years ago
    by Troy.Tsai
  • Suggested Answer

    LM4041-N: Max Voltage 0 Locked

    869 views
    2 replies
    Latest over 8 years ago
    by Marcoo Z
  • Suggested Answer

    TPS65185: RSL vs. RGZ 0 Locked

    1276 views
    3 replies
    Latest over 8 years ago
    by Richard Solarski
  • Answered

    TPS54360: questions about inverting buck-boost topology 0 Locked

    2299 views
    7 replies
    Latest over 8 years ago
    by YangZhang
  • Suggested Answer

    BQ25601: VAC OVP specification 0 Locked

    1192 views
    4 replies
    Latest over 8 years ago
    by Ning T
  • Not Answered

    LM5022: Suitability of LM5022 chip and problem solving for boost converter 0 Locked

    1791 views
    4 replies
    Latest over 8 years ago
    by Garrett Roecker
  • Not Answered

    UC3906: Battery Charger works OK with battery only but not when a load is connected to the battery 0 Locked

    904 views
    3 replies
    Latest over 8 years ago
    by Raheem
  • Answered

    Lightning Surge Consideration 0 Locked

    733 views
    1 reply
    Latest over 8 years ago
    by Thomas Amlee
  • Not Answered

    LM5023-2NBEVM: LM5023 19V 65W Notebook Adapter Evaluation Module --- need Altium project files 0 Locked

    6452 views
    12 replies
    Latest over 8 years ago
    by Ulrich Goerke
  • Suggested Answer

    how to cut off the typeC adapter supply by the PD controller TPS65982 0 Locked

    879 views
    2 replies
    Latest over 8 years ago
    by Eric Beljaars
<>