Hello all,
I purchased a TPS61088EVM-677 board, tested it by playing around with different output voltages, and finally agreed to use 4.5V3A output for my heating project design.
I went on to design the schematics referring to the EVM schematics and artwork, programmed for 4.5V3A output, However my board design can only provide 2.5A which is not
enough for my load to heat up to our desired temperature. The EVM worked well with about 4.5V3.3A. (I am pretty new to power designs)
Below is part of my schematics and artwork capture.
Thank you!