About k3conf

xu ji

Intellectual 335 points

Hi,

In TDA4 what is k3conf? how to integrated it and how to use it?

any guide can be given?

Thanks

over 3 years ago

+1 Hemant Hariyani over 3 years ago

TI__Expert 8385 points

Hello,

k3conf is a diagnostic utility for TDA4 and other Keystone 3 devices.

If your filesystem does not already have it, you can get it from:

https://git.ti.com/cgit/k3conf/k3conf/tree/

For the finctionality, you can run

k3conf --help

This will list all the commands and what they can do.

Regards

Hemant

0 xu ji over 3 years ago in reply to Hemant Hariyani

Intellectual 335 points

thanks for reply and the k3conf build in RTOS or Linux side?

0 Keerthy J over 3 years ago in reply to xu ji

TI__Guru**** 154990 points

Hi Xu,

By default Linux SDK has support for k3conf & even QNX. Which OS are you using?

- Keerthy

0 xu ji over 3 years ago in reply to Keerthy J

Intellectual 335 points

Linux OS，I find it,and more question does the Dynamic Voltage Frequency Scaling need use k3conf in TDA4?

does 0801 SDK release realized the DVFS? if not how to enable it?

0 Keerthy J over 3 years ago in reply to xu ji

TI__Guru**** 154990 points

xu ji said:
nd more question does the Dynamic Voltage Frequency Scaling need use k3conf in TDA4?

does 0801 SDK release realized the DVFS? if not how to enable it?

No support for DVFS on Hwardware & SDK. Closing this thread as k3conf is already answered.

- Keerthy

Processors

Processors forum

About k3conf