TMDS64EVM: TMDS64EVM Flashing is getting failed.

Ankita Vaghela

Other Parts Discussed in Thread: UNIFLASH

I am trying to flash a hello world example code , taken from mcu plus sdk version 08_05_00_24 but when I am executing sbl_uart_uniflash command it is giving error like [ERROR] XMODEM recv failed, no response OR incorrect response from EVM OR cancelled by user,Power cycle EVM and run this script again !!!

Can you please provide a solution?

over 2 years ago

0 Prashant Shivhare over 2 years ago

TI__Guru 72411 points

Hi Ankita,

You are most likely using an HS-FS board type, because of which the flashing fails. The sbl_uart_uniflash.release.tiimage is a GP image, while the corresponding HS-FS image is named sbl_uart_uniflash.release.hs_fs.tiimage

If you are using HS-FS board type, please follow the below FAQ to flash successfully.

https://e2e.ti.com/support/processors-group/processors/f/processors-forum/1183777/faq-am64x-how-can-i-flash-soc-initialization-binaries-on-hs---fs-hw-versions

Please let me know if the above helps.

Regards,

Prashant

0 Ankita Vaghela over 2 years ago in reply to Prashant Shivhare

Prodigy 110 points

Thank you Prashant for the help.Flashing is happening, but I am flashing hello world example code ,I am not getting output of the program.

0 Prashant Shivhare over 2 years ago in reply to Ankita Vaghela

TI__Guru 72411 points

Hi Ankita,

Happy to help!!!

About the other issue, I believe you have created another thread for the same. We will provide support for the other issue in its respective thread.

Regards,

Prashant

0 Ankita Vaghela over 2 years ago in reply to Prashant Shivhare

Prodigy 110 points

Okay. I have already created other thread for the same.

Processors

Processors forum

TMDS64EVM: TMDS64EVM Flashing is getting failed.